What Problems Will Be Caused By Improper CNC Processing Of The Communication Filter Cavity? Although This Processing Technology Has Many Advantages, If The Process Is Not Properly Arranged, It Will Also Cause The Following Problems:

What problems will be caused by improper CNC processing of the communication filter cavity?

Communication cavity is very common in enterprise manufacturing. This kind of part is mainly made of CNC processing equipment. Although this processing technology has many advantages, if the process is not properly arranged, it will also cause the following problems:

1. The CNC operation process is too scattered

The main reason for this type of problem is that the process arrangement and programming of the communication cavity are too simple, which simplifies the whole process of operation. Although it is easy to arrange the tool set by using one knife for a long time, the processing form is very difficult. will be relatively simple. In this case, it is easy to cause that the product quality cannot be guaranteed to meet the standard, and the normal output power of the machine cannot be fully utilized. Therefore, if the quantitative production is completed through the CNC output process, it is first necessary to fully understand the numerical control knowledge and try more. Only by deeply understanding the necessary knowledge and using the method of process convergence many times, it will naturally show its advantages in the long run. Advantage. After the use of process aggregation, the unit processing time increases. We arrange the two pieces of equipment face to face and complete the operation of two pieces of equipment by one person. The power has been greatly improved, and the quality has also been well ensured.

2. The order of CNC operation is unreasonable

Some communication cavity CNC processing implementers often take the small problems in preparation seriously, especially in the output sequence, there are often unreasonable arrangements, which are also prone to problems. Under normal circumstances, the development of CNC is in principle completed according to the requirements of ordinary machining technology, such as changing the rough knife to the fine knife, from the inside to the outside, selecting the specified cutting parameters, etc., so that the quality can be guaranteed to a certain extent.

Although the G00 command can bring great convenience to the processing of the communication cavity during programming and operation, if the setting is not appropriate, it will often cause the speed to return to zero too quickly, the accuracy will be reduced, and the surface of the guide rail will exist. Injury and other adverse consequences. If there are obstacles in the zero-returning channel, it is easy to bump the workpiece and the production failure of the equipment. Therefore, if the G00 command is used during normal operation, the relevant debugging work should be done well, and it should not be done arbitrarily.

In the process of CNC machining, great attention must be paid to the retrieval and trial operation of specific programs. After the program is written into the set system, the implementer should learn to use various control keys to retrieve the process and complete the test. If necessary, the program should be slightly revised to ensure its efficiency of the program. At the same time, before the formal operation program is completed, it is necessary to make the program the main control to conduct a trial run to confirm whether the processing channel is consistent in principle.